ENVIROPRO SMP REMOVAL

Sub Surface Probe Removal

Carefully excavate around the probe head using a hand trowel. Make sure that you  do not damage the probe cable to a depth of 100mm below the top of the  probe cap
 

Fitting the Clamp Tool

Loosen the wing nut on the clamp tool and swing the two halves apart. Place  the clamp over the probe, ensuring the cable gland lines up with the  slots in the top faces of the tool.
Slip the locking bolt through the slot in the clamp and tighten the wing nut firmly
Grip the handles of the tool firmly and rock it back and forth until you can achieve 1 degree of rotation. Once the probe has broken contact with  the soil in this fashion, you should be able to pull the probe  vertically from the soil.
For probes of 1m and greater length, you may need some mechanical  assistance to lift the probe. Slide a length of rope or chain over the  two handles, leaving a loop of approximately 300mm in length. Thread the end of the chain / rope over the hook on a star picket puller or high  lift jack. Then work the Jack / puller to lift the probe free from the  soil.